10
GPS/GPS-A OPERATION
10-8
GPS Memory name programming 2.
u Push D-pad() to select “NAME,” and then push D-
pad(Ent).
i Rotate [DIAL] to select the first character.
• Selectable input characters are Upper case letters, Low-
er case letters, Numbers or Symbols.
• The selected character blinks.
• Push D-pad() to move the cursor backward or forward.
• While selecting a character, push [QUICK]
to change
the character to an upper case or lower case letter.
• While selecting a digit, push [QUICK]
to open the
input mode selection window.
• A space can be entered in any input mode selected.
• Rotate [DIAL] counter clockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously delete the characters,
first to the right, and then to the left of the cursor.
• See page 2-7 for programming details.
o Push D-pad() to move the cursor to the second
digit.
!0 Repeat steps i and o to enter a GPS Memory
name of up to 16 characters, including spaces.
!1 After entering the name, push D-pad(Ent).
Character
type selection
screen
(Example)
When entering
“HOME”
Continued on the next page ☞
GPS memory operation ■ (Continued)
To Next Page
Loading...
Need help?
General
