Icom ID-51A Advanced Instructions

10
GPS/GPS-A OPERATION
10-15
GPS memory operation ■
GPS alarm setting (Continued) D
Push [MENU] q .
Push D-pad( w ) to select the root item (“GPS”), and
then push D-pad(Ent).
D-pad
(�)
(Ent)
Push D-pad( e ) to select “GPS Alarm,” and then
push D-pad(Ent).
Push D-pad( r ) to select “Alarm Select,” and then
push D-pad(Ent).
Push D-pad( t ) to select “RX,” and then push D-
pad(Ent).
• If you want to set the alarm to a specied GPS memory
channel, select “Memory,” then push D-pad(Ent). And
then, select the channel in the GPS memory group.
y Push [MENU] to exit the Menu screen.
• When a set station is in the approximate 1 kilometer
range, GPS Alarm beeps once, and when it is in the ap-
proximate 500 meter range, beeps three times.
(Default: Both)
• When the GPS alarm beeps, “GPS ALARM” pops up on
the screen and then the S icon blinks.
• To cancel the GPS alarm, repeat step t and select
“OFF.”
NOTE: When “RX” or a GPS memory channel is se-
lected in step t, the GPS alarm sounds depend on
the “Alarm Area (RX/Memory)” setting in the Menu
screen. (p. 16-38)
(MENU > GPS > GPS Set > Alarm Area (RX/Memory))
NOTE: Even if “RX” is selected in step t, and the
received signal has no position, the GPS alarm does
not sound.
Example: Alarm Area (RX/Memory)
Alarm Setting is set to RX.
• GPS Alarm beeping screen
The pop up is displayed
and beeps sound, de-
pending on the setting
of the alarm area.
Blinks
“RX” is
displayed.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)