Icom ID-51A Advanced Instructions

2
USING A microSD CARD
2-10
Loading the saved settings file that are on the microSD card (Continued) ■
Push D-pad(Ent) to select the file, and then the “Keep y
'SKIP' settings in Repeater List?” appears.
D-pad
(�)
(Ent)
Push D-pad( u ) to select “YES” or “NO.”
• When “YES” is selected, the skip settings of the repeater
list are retained. (p. 9-36)
Push D-pad(Ent), “Load le?” appears. i
Push D-pad( o ) to select “YES,” then push D-pad(Ent)
to start the file check.
• While checking the le, “CHECKING FILE” and a prog-
ress bar are displayed.
!0 After checking, settings data loading starts.
• While loading, “LOADING” and a progress bar are dis-
played.
!1 After loading, “COMPLETED!” appears.
To complete the loading, reboot the transceiver.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)