Icom ID-51A

12
MEMORY CHANNEL PROGRAMMING
12-11
Rotate [DIAL] to select a desired character. y
• Selectable input characters are Upper case letters, Low-
er case letters, Numbers or Symbols.
• The selected character blinks.
• Push D-pad() to move the cursor backward or forward.
• While selecting a character, push [QUICK]
to change
the character to an upper case or lower case letter.
• While selecting a digit, push [QUICK]
to open the
input mode selection window.
• A space can be entered in any input mode selected.
• Rotate [DIAL] counter clockwise to enter a space.
• Push [CLR]
to delete the selected character, or hold
down [CLR]
to continuously delete the characters,
first to the right, and then to the left of the cursor.
• See page 2-7 for programming details.
Push D-pad( u ) to move the cursor to the second
digit.
Repeat steps i y and u to enter the desired channel
name of up to 16 characters.
Push D-pad(Ent) to save, and exit the Memory name o
edit mode.
!0 Push D-pad() to select “<<Write>>,” and then push
D-pad(Ent).
• The conrmation screen “Overwrite?” appears.
!1 Push D-pad() to select “YES,” and then push D-
pad(Ent).
• Returns to the screen viewed before entering the Select
Memory write mode in step w.
Continued from the previous page
Rotate [DIAL] to select “I”.
Push D-pad() to move
the cursor to the second
digit.
Rotate [DIAL] to select “D.”
Repeat steps y and u
until the desired memory
name is programmed.
Push D-pad(Ent) to save
the name and exit the
Memory name edit mode.
Push D-pad() to select
“<<Write>>,” and then
push D-pad(Ent.)
Push D-pad() to select
“YES,” and then push D-
pad(Ent).
Returns to the screen
viewed before entering
the Select Memory write
mode.
Memory name is dis-
played.
Programming memory/bank/scan name ■
Programming memory name, bank name or scan D
name (Continued)
[DIAL]
Previous view