Icom ID-51A Advanced Instructions

13
SCAN OPERATION
13-6
When a scan name is assigned.
When a scan name is assigned, the scan type can be
set by selecting the scan name from the scan type list.
(Step r on page 13-5.)
NOTE: The scan name is not displayed during a
scan.
• When the scan name is assigned
• When the program link name is assigned
• When the scan name is not assigned
• When the program link name is not assigned
VFO mode scan (continued) D
Scan name
“Scan 0”
When a program link name is assigned.
When a program link name is assigned, the scan type
can be set by selecting the program link name from the
scan type list. (Step r on page 13-5.)
NOTE: The program link name is not displayed dur-
ing a scan.
Scan edges
Program link
Program link
name “Link 0”
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)