Icom ID-51A

16
MENU SCREEN
16-29
Voice TX items (Continued) ■
Repeat Time (Default: 5sec)
Voice TX > TX Set > Repeat Time (Repeat Time)
Set the repeat interval to between 1 and 15 seconds (in 1 second steps).
The transceiver repeatedly transmits the recorded voice audio at this inter-
val.
NOTE:
The recorded voice audio is repeatedly transmitted for up to 10 minutes.
Even if 10 minutes passes while transmitting, the complete voice audio is
transmitted.
TX Monitor (Default: ON)
Voice TX > TX Set > TX Monitor (TX Monitor)
Turn the TX Monitor function ON or OFF.
• OFF : The TX voice audio is not heard from the speaker.
• ON : The TX voice audio is heard from the speaker.
<<Single TX>>
Voice TX > TX Set > <<Single TX>>
The transceiver transmits the recorded voice audio once.
• To cancel the voice transmission, push [CLR] .
Convenient! ✓
You can transmit the recorded voice audio also from the QUICK MENU
screen. (p. 17-3)
<<Repeat TX>>
Voice TX > TX Set > <<Repeat TX>>
The transceiver repeatedly transmits the recorded voice audio for up to 10
minutes at the specified interval in the Repeat Time item.
• To cancel the voice transmission, push [CLR] .
Convenient! ✓
You can transmit the recorded voice audio also from the QUICK MENU
screen. (p. 17-3)
NOTE:
• The recorded voice audio is repeatedly transmitted for up to 10 minutes.
Even if 10 minutes passes while transmitting, the complete voice audio
is transmitted.
• One of the following steps will cancel the transmission.
- Push [PTT].
- Turn OFF the power, then turn it ON again.
- Push any key (except for [POWER]).
- Rotate [DIAL].
Previous view