16
MENU SCREEN
16-53
Repeater Group (01 to 25)
Group name
Repeater group name of up to 16 alphanumeric charac-
ters
The Skip setting can be turned ON or OFF in the QUICK MENU screen.
Repeater List
NAME Repeater name of up to 16 alphanumeric characters
SUB NAME Repeater sub name of up to 8 alphanumeric characters
CALL SIGN Repeater call sign
GW CALL SIGN Gateway call sign
GROUP Repeater group where the repeater is assigned
USE(FROM)
Select whether or not to use the repeater as an access
repeater (FROM) in the DR mode
FREQUENCY*
1
Operating frequency of the access repeater
DUP*
1
Duplex setting to use the access repeater
OFFSET FREQ*
1
Frequency offset to use the access repeater
POSITION
Position data accuracy level (“None,” “Approximate” or “Ex-
act”)
LATITUDE*
2
Latitude position of the repeater
LONGITUDE*
2
Longitude position of the repeater
UTC OFFSET
Time difference between UTC (Universal Time Coordinat-
ed) and the local time
*
1
Appears only when USE(FROM) is set to “YES.”
*
2
Appears only when POSITION is set to “Approximate” or “Exact.”
NOTE: When the repeater is used for a simplex communication, refer to
the list below to set the settings.
NAME
Enter the desired name of up to 16 alphanumeric charac-
ters
SUB NAME
Enter the desired sub name of up to 8 alphanumeric char-
acters
CALL SIGN Blank
GW CALL SIGN —
GROUP Set the desired repeater group
USE(FROM) YES
FREQUENCY Frequency for the Simplex operation
DUP OFF
OFFSET FREQ —
POSITION —
UTC OFFSET —
DV Memory items (Continued) ■
To Next Page
Loading...
