Icom ID-51A Advanced Instructions

6
BC RADIO OPERATION
6-11
Frequency programming3.
!2 Push D-pad() to select “FREQUENCY,” and then
push D-pad(Ent).
• A cursor appears and blinks.
D-pad
(�)
(Ent)
!3 Rotate [DIAL] to input the frequency.
• AM: 520 to 1710 kHz
• FM: 76.0 to 108.0 MHz
!4 Push D-pad() to move the cursor backward or for-
ward to edit the frequency.
!5 Repeat steps !3 and !4 to enter the frequency.
!6 After entering, push D-pad(Ent).
Skip setting4.
!7 Push D-pad() to select “SKIP,” and then push D-
pad(Ent).
!8 Push D-pad() to select whether or not to use the
channel in the BC Radio memory.
• OFF: You can select the channel in the BC Radio
memory.
• Skip: The channel does not appear in the BC Radio
memory.
!9 After selecting, push D-pad(Ent).
Writing BC Radio Memory5.
@0 Push D-pad() to select “<<Add Write>>,” and then
push D-pad(Ent).
• If a previously added BC Radio memory is edited, select
“<<Overwrite>>.”
@1 Push D-pad() to select “YES,” and then push D-
pad(Ent).
To cancel the programmed data:
To cancel the programmed q
data, push [CLR]
to
display “Cancel edit?.”
Push D-pad( w
) to select
“YES,” and then push D-
pad(Ent) to cancel pro-
gramming and return to
the BC Radio Memory’s
channel list screen.
(Example)
When entering
“88.9”
(Example)
When “FM-K Station” is
programmed in Bank K.
Select
Adding or editing BC Radio memory ■ (Continued)
The list of BC Radio Bank K
is displayed.
Previous view

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)