EasyManuals Logo

Icom ID-51A Advanced Instructions

Icom ID-51A
369 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
7
D-STAR INTRODUCTION
7-3
In the DR mode, the transceiver has three communica-
tion forms, as shown below.
• Local area call : To call through your local area (ac-
cess) repeater.
• Gateway call : To call through your local area (ac-
cess) repeater, repeater gateway and
the internet to your destination re-
peater or individual station’s last used
repeater, using call sign routing.
Simplex call : To call another station not using a re-
peater.
NOTE:
• Programming the repeater list is required for DR mode operation. (pp. 9-23 to 9-31)
Before operating in the DV mode, be sure to check whether the repeater is busy, or not. If the repeater is busy,
wait until it is clear, or ask for a “break” using a method acceptable to your local procedures.
The transceiver has a Time-Out Timer function for digital repeater operation. The timer limits a continuous trans-
mission to approximately 10 minutes. Warning beeps will sound approximately 30 seconds before time-out and
then again immediately before time-out.
INTERNET
Access repeater
Local area call
Gateway call
Simplex call
Hamacho
repeater
Hamacho area
Hirano area Sapporo area
Hirano
repeater
Sapporo
repeater
Communication Form in the DR mode
Previous view

Table of Contents

Other manuals for Icom ID-51A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom ID-51A and is the answer not in the manual?

Icom ID-51A Specifications

General IconGeneral
Frequency Range144-148 MHz, 430-450 MHz
Antenna ConnectorSMA
GPS ReceiverYes
WaterproofIPX7
ModesFM, DV
Weight255 g
Memory Channels1304 channels
Output Power5W (High), 2.5W (Middle), 0.5W (Low)

Related product manuals