Programming IDEC SmartRelay
96 IDEC SmartRelay Manual
3.6.13 Deleting the circuit program and password
To delete a circuit program and the password if one is
defined:
1. Switch the IDEC SmartRelay to programming mode
(main m
enu).
>Program..
Card..
Setup..
Start
IDEC SmartRelay opens the
main menu
2. On the main menu, press or to move the ’>’ cursor to
’Program’. Press OK.
>Edit..
Clear Prg
Password
Msg Config
IDEC SmartRelay changes to
the programming menu
3. On the programming menu, move the ’>’ cursor to ’Clear
Prg’: Press
or
4. Confirm ’Clear Prg’: Press OK
Clear Prg
>No
Yes
To cancel deletion of the circuit program, leave the ’>’ cursor
at ’No’ and press OK.
If you are sure that you want to delete the circuit program
from memory
:
5. Move the ’>’ cursor to ’Yes’: Press
or
6. Press OK.
To prevent unintentional
deletion of your circuit
program, you are prompted to
enter your password (provided
you have assigned one).
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
