Programming IDEC SmartRelay
IDEC SmartRelay Manual 101
Note
To disable summertime/wintertime conversion in this menu, you
merely confirm ‘Off’ with OK.
Note
Summertime/wintertime conversion only functions when IDEC
SmartRelay is operating (in RUN or STOP status). It does not func-
tion when IDEC SmartRelay is in buffered operation (see Chapter
4.3.3).
3.6.15 Synchronization
Time synchronization between IDEC SmartRelay and the
connected expansion modules can be enabled/disabled in
programming mode by means of the real-time clock menu
(“Clock” menu item).
1. Switch the IDEC SmartRelay to programming mode.
2.
You are no
w in the main menu, and want to select
‘Clock’: Press or
3. Confirm ‘Clock’: Press OK
4. Move the ‘>’ cursor to ‘Sync’: Press or
5. Apply ‘Sync’: Press OK
IDEC SmartRelay shows the following display:
The current setting of the automatic synchronization function
is displayed in the bottom row. The default setting is ‘Off’:
disabled.
To Next Page
Loading...
Need help?
General
