Programming IDEC SmartRelay
IDEC SmartRelay Manual 97
7. Enter your password.
8. Press OK. The circuit pro
gram and the password are
deleted.
Note
In case that you forget the password, you can delete the circuit
program and the password using WindLGC. See the onlinehelp for
WindLGC for more details.
For a base module with versions 3 and earlier, you can delete the
circuit program and the password by inputting a wrong password on
“Clear Prg” menu three times in a row.
For a base module with versions 4 or later, you can delete the circuit
program and the password by inputting a wrong password on
“Clear Prg” menu a hundred times in a row.
3.6.14 Summertime/wintertime conversion
You can enable or disable automatic summertime/wintertime
conversion
• in parameter assignment mode by calling the “Set..”
menu co
mmand
• in programming mode by calling the “Setup” menu
co
mmand.
To enable/disable automatic S/W Time conversion in
programming mode:
1. Switch IDEC Smar
tRelay to programming mode.
2. You are now in the main menu and want to select the
’Setup’ men
u comma
nd: Press
or
3. Confirm ’Setup’: Press OK
4. Move the ’>’ cursor to ’Clock’: Press
or
5. Confirm ’Clock’: Press OK
6. Move the ’>’ cursor to ’S/W Time’: Press
or
7. Confirm ’S/W Time’: Press OK
IDEC SmartRelay shows the following display:
To Next Page
Loading...
Need help?
General
