IDEC SmartRelay functions
204 IDEC SmartRelay Manual
Key input simulation in the active message text
You can enable the four cursor keys C , C , C and C
in an active message text by pressing ESC plus the
relevant cursor key.
Setting the Par parameter
View in programming mode:
Press to select a line for the message text.
Press
and to select the letter to be displayed in the text.
To move the cursor from one position to the other, press
and
.
The list of available characters is the same as
for the circuit
program name. The character set is found in Chapter 3.6.4.
When you enter message text from the IDEC SmartRelay
b
ase module
, you can only enter characters from the
ISO8859-1 character set. To enter text from another
language, you must enter the text in WindLGC.
Note that the number of characte
rs per lin
e of message text
can be greater than the number of character positions on the
IDEC SmartRelay Display.
Press OK to confirm your change
s, and press ESC to exit
the editing mode.
To Next Page
Loading...
Need help?
General
