Technical data
308 IDEC SmartRelay Manual
(1): 8 V DC (Version 1 to 4 specifications)
(2): 1.0 mA (Version 1 to 4 specifications)
(3): 1.5 mA (Version 1 to 4 specifications)
(4): When FL1E-H12SND or FL1B-M08B1S2 are switched on, signal 1 is sent to the
digital outputs for about 50 microseconds. Take this into account, especially when
using devices that react to short pulses.
Short circuit–proof cos 1 not applicable for this module
Short circuit-proof cos 0.5 to 0.7 not applicable for this module
Parallel output circuit for power increase Not permitted
Protection of output relay (if desired)
Switching rate
Mechanical
Electrical 10 Hz
Ohmic load/lamp load 10 Hz
Inductive load 0.5 Hz
FL1B-M08B1S2
To Next Page
Loading...
Need help?
General
