Programming IDEC SmartRelay
IDEC SmartRelay Manual 61
Block representation on the IDEC SmartRelay display
The figure below shows a typical view of the IDEC
SmartRelay display. As you can see, it can show only one
block at a time. We have therefore introduced block numbers
to help you check the circuit structure.
View of the IDEC SmartRelay
Input
This connector is
not required
Block
Block number -assigned
by IDEC SmartRelay
Output
Another block is connected
at this point
Assigning a block number
IDEC SmartRelay assigns each new block in a circuit
program a
block number.
IDEC SmartRelay uses these block numbers to indicate the
block inte
rconnections. This means that these numbers are
mainly an aid to your orientation in the circuit program.
I1
I2
I3
1
B1
B2
B2
1
B3
Q1
B1
B1
I4
I5
I6
1
B1
Q1
x
B3
x
x
x
Block numbers
These blocks are
interconnected
Scrolling the circuit program using the key
The figure above shows you three views of the IDEC
SmartRelay display, which represent the circuit program. As
you can see, IDEC SmartRelay interconnects the blocks
using their numbers.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
Need help?
General
