Inateck P6 - LED Indicator; Beeper

19
1.3. LED Indicator
The LED indicators on Inateck P6 can help the user know more about the current
operation status.
1.4. Beeper
The beeper built in Inateck P6 can help the user to know about the current operation
status.
LED Status Meaning
Green LED ashes once Barcode successfully read and uploaded to computer
Blue LED ashes once Barcode successfully read and saved in bu󱐯er, but not uploaded to
computer
Blue LED stays on Inateck P6 scanner on setup status
Yellow LED blinks（light/shade
ratio0.5s : 0.5s）
Low battery
Red LED stays on Inateck P6 scanner in charge (Red LED o󱐯 when battery is full)
Beeping Meaning
One short high note (100ms) Read barcode successfully
Two short high notes (the same) Barcode scanner shutdown
One short high note (20ms) Data upload from scanner to host
One long high note (400ms) Wrong Setup（on setup status, blue LED stays on）
Invalid scanning due to full buffer. (Scanned barcode not
saved)
Pairing Failure (Occurs only during the pairing process)
One or several long high notes (800ms） USB being configured (It happens when USB cable is
inserted)
Three chord sounds Enter setup mode（Blue LED on）
Exit setup mode（Blue LED o󱐯）
Two short notes (tone from low to high) Correct Setup
Two short beeps (tone from high to low) The connection between Inateck P6 and computer is
disrupted.