Inateck P6 - Start Character Transmission

56
3.10.3. Start Character Transmission
Decide whether to include the Start character, which is limited to be “0”or “1”, in the data
being transmitted. Inateck P6 defaults “Transmit UPC-E Start Characters”.
Operations are as below if you do not want to Transmit UPC-E Start Characters:
1. Read the "Enter Setup" barcode;
2. Read the " Do Not Transmit UPC-E Start Character " barcode;
3. Read the "Exit with Save" barcode.
(*) Transmit UPC-E Start Character Do Not Transmit UPC-E Start
Character
Enter Setup
Exit without Save
Exit with Save