Inateck P6 - Checksum Verification

53
3.9.3. Checksum Verication
Decide whether to Transmit UPC-A Checksum by scanning correspondent barcode
below. Inateck P6 defaults “Transmit UPC-A Checksum”.
Operations are as below if you want to enable UPC-A and transmit UPC-A Checksum:
1. Read the "Enter Setup" barcode;
2. Read the "Enable UPC-A" barcode;
3. Read the "Transmit UPC-A Checksum" barcode;
4. Read the "Exit with Save" barcode.
(*) Transmit UPC-A Checksum Do Not Transmit UPC-A Checksum
Enter Setup
Exit without Save
Exit with Save