Inateck P6 - Code; Enable;Disable Code

31
3.2. Code 11
3.2.1. Enable/Disable Code 11
Decide whether to include Enable/Disable characters in the data being transmitted by
scanning relevant barcodes below, with disable Code 11 as default.
Enable Code 11 Disable Code11
Enter Setup
Exit without Save
Exit with Save
Note: Read the "Disable Code 11" barcode will make the scanner not being able to read
the Code 11 barcode. Thus, if the scanner cannot read the Code 11 barcode, please try to
scan "Enable Code 11" to reset.
For example: Enable Code 11.
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 11" barcode;
3. Read the "Exit with Save" barcode.