Inateck P6 - Start;Stop Transmission

36
3.4.2. Start/Stop Transmission
Decide whether to include the Start/Stop characters in the data being transmitted
through selecting correspondent barcode below. Inateck P6 takes disabling transmitting
Code39 Start/ Stop Characters as default.
For example: Steps to not transmit code 39 Start/Stop Characters are as below:
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 39" barcode; (If Code 39 is disabled, it is needed to enable it);
3. Read the "Do Not Transmit Code 39 Start/Stop Characters" barcode;
4. Read the "Exit with Save" barcode.
Transmit Code 39 Start/S top
Characters
(*) Do Not Transmit Code 39 Start/
Stop Characters
Enter Setup
Exit without Save
Exit with Save