Inateck P6 - UPC-A Output 0

52
3.9.2. UPC-A output “0”
Decide whether to add "0" in the output of UPC-A data by scanning correspondent
barcode below. Inateck P6 takes UPC-A Do Not output “0” as default.
Operations are as below if you want to Output UPC-A ‘0’:
1. Read the "Enter Setup" barcode;
2. Read the " UPC-A Output "0" " barcode;
3. Read the "Exit with Save" barcode.
UPC-A Output "0" (*) UPC-A Do Not Output "0"
Enter Setup
Exit without Save
Exit with Save