Inateck P6 - UPC-E Symbology Configuration

54
3.10. UPC-E
3.10.1. Enable / Disable UPC-E
Decide whether to Enable UPC-E by scanning correspondent barcode below. Inateck P6
defaults “Enable UPC-E” .
Operations are as below if you want to enable UPC-E barcode:
1. Read the "Enter Setup" barcode;
2. Read the "Enable UPC-E " barcode;
3. Read the "Exit with Save" barcode.
(*) Enable UPC-E Disable UPC-E
Enter Setup
Exit without Save
Exit with Save