Inateck P6 - Manual Mode

25
1.5.4. Manual Mode
Under this Manual Mode, the Inateck P6 Scanner will emit a red light line which indicates
the scanner could scan if the user keeps pressing the Trigger. And the scanning will not
stop until the scanner under the following situation.
* Read a barcode successfully;
* Release the Trigger;
Exit with Save
Manual Mode Enter Setup
Exit without Save
For Example, If you want to set the scanner into manual mode, you may need to:
1. Read the "Enter Setup" barcode;
2. Read the "Manual Mode" barcode;
3. Read the "Exit with Save" barcode.