Inateck P6 - Checksum Verification

58
3.10.5. Checksum Verication
Decide whether to transmit UPC-E Checksum by scanning correspondent barcode below.
Inateck P6 defaults “Transmit UPC-E Checksum”.
Operations are as below if you want to transmit UPC-E Checksum:
1. Read the "Enter Setup" barcode;
2. Read the "Enable UPC-E" barcode;
3. Read the "Transmit UPC-E Checksum" barcode;
4. Read the "Exit with Save" barcode.
(*) Transmit UPC-E Checksum Do Not Transmit UPC-E Checksum
Enter Setup
Exit without Save
Exit with Save