Inateck P6 - Upc-A; Enable; Disable UPC-A

51
3.9. UPC-A
3.9.1. Enable / Disable UPC-A
Decide whether to enable UPC-A barcode by scanning correspondent barcode below.
Inateck P6 defaults “Disable UPC-A barcode”.
Operations are as below if you want to enable UPC-A barcode:
1. Read the "Enter Setup" barcode;
2. Read the "Enable UPC-A " barcode;
3. Read the "Exit with Save" barcode.
Enable UPC-A (*) Disable UPC-A
Enter Setup
Exit without Save
Exit with Save