9
QUICK START
Settings of the Inateck P6 Barcode Scanner can be changed by Scanning the setup
barcodes included in this manual. This section describes the procedure of setting the
Inateck P6 Barcode Scanner by scanning the setup barcodes. Examples are demonstrated
as below.
Step 1: Turn on inateck P6 Barcode Scanner.
Switch the Power Switch to “On” mode to get the scanner turned on. Click the Trigger
(Scan button), and Inateck P6 will emit a red laser.
Step 2: Enter the Setting Mode.
Scan “Enter setup””barcode, and Inateck P6 Barcode Scanner will respond with three
chord sounds, and LED2 indicator will be on with color becoming blue.
Step 3: Read a Setup barcode.
Change scanner setting by scanning certain function setup barcode (e.g.: ‘Enable
codabar’ barcode). The Inateck P6 Barcode Scanner will response with two beeps (tone
ascending from low to high), and LED2 indicator will be on with color becoming blue.
Enter setup
Step 4: Exiting the Setting Mode.
Scan “Exit with save” barcode to nish the setup. Inateck P6 Barcode Scanner will respond
with three chord sounds, and blue LED2 indicator will automatically be turned o.
Note: The Inateck P6 Barcode Scanner will respond with a long beep if any setup error
occurs, for instance, none-setting barcodes are scanned under setting mode. Setup errors
can be canceled by scanning barcode “Exit without Save”.
Enable Codabar
Exit with save
Exit without save
To Next Page
Loading...
