Inateck P6 - Enable; Disable UPC-E 1

55
3.10.2. Enable / Disable UPC-E 1
Decide whether to Enable UPC-E 1 by scanning correspondent barcode below. Inateck P6
defaults “Disable UPC-E 1”.
Note: Most of the Start character of UPC-E is 0, Please Set the scanner to able to read the
UPC-E barcode before enabling the UPC-E 1. Inateck P6 defaults “Disable UPC-E 1”.
Operations are as below if you want to enable UPC-E1 barcode:
1. Read the "Enter Setup" barcode;
2. Read the "Enable UPC-E " barcode;
3. Read the "Enable UPC-E1 " barcode;
4. Read the "Exit with Save" barcode.
Enable UPC-E 1 (*) Disable UPC-E 1
Enter Setup
Exit without Save
Exit with Save