Inateck P6 - Stop Code of Barcode Setting

70
4.2. Stop Code of Barcode Setting
Decide whether to apply Enter as the stop character of barcode data by scanning
correspondent barcode below. Inateck P6 defaults to “Apply Enter as the stop character
of barcode”.
Steps to not apply Enter as Stop Character are as below:
1). Read the "Enter Setup" barcode;
2). Read the "Do Not Apply Enter as Stop Character" barcode;
3). Read the "Exit with Save" barcode.
(*) Apply Enter as Stop Character Do not Apply Enter as Stop Character
Enter Setup
Exit without Save
Exit with Save