Inateck P6 - Additional Code; Two Digits Additional Code

75
Enable Two Digits Additional Code (*) Disable Two Digits Additional
Code
Enter Setup
Exit without Save
Exit with Save
4.6. Additional Code
The occurrence of additional code can be found in several types of bacode like EAN-
8,EAN-13,ISBN,ISSN,UPC-A and UPC-E. Being 2 or 5 characters, additional code is usually
on the right side of the main code but with shorter height. Inateck P6 will only be able to
read the main code if additional code is disabled.
4.6.1. Two digits Additional Code
Decide whether to read two digits additional code, which applies to EAN-8, EAN-13, ISBN,
ISSN, UPC-A and UPC-E, by scanning correspondent barcode below. Inateck P6 defaults to
“Disable Two Digits Additional Code”.
Steps to Enable Two Digits Additional Code are as below:
1). Read the "Enter Setup" barcode;
2). Read the "Enable Two Digits Additional Code" barcode;
3). Read the "Exit with Save" barcode.