Inateck P6 - Code 128; Enable; Disable Code 128

34
3.3. Code 128
3.3.1. Enable / Disable Code 128
Decide whether to enable Code 128. Inateck P6 Scanner defaults “Enable Code 128”.
Note: Read the "Disable Code 128" barcode will make the scanner unable to read Code
128 barcode. Thus, if the scanner cannot read the Code 128 barcode, please try to scan
"Enable Code 128" to reset.
For Example: Steps to enable Code 128 are as below:
1. Read the "Enter Setup" barcode;
2. Read the "Enable Code 128" barcode;
3. Read the "Exit with Save" barcode.
(*) Enable Code 128 Disable Code 128
Enter Setup
Exit without Save
Exit with Save