Inateck P6 - Checksum Verification

43
(*)Transmit EAN-8 Checksum Do Not Transmit EAN-8 Checksum
Enter Setup
Exit without Save
Exit with Save
3.6.2. Checksum Verication
Decide whether to transmit EAN-8 Checksum via selecting correspondent barcode below
to scan. Inateck P6 defaults “Transmit EAN-8 Checksum”.
Operations are as below if you want to enable EAN-8 and transmit EAN-8 Checksum:
1. Read the "Enter Setup" barcode;
2. Read the "Enable EAN-8" barcode;
3. Read the "Transmit EAN-8 Checksum" barcode;
4. Read the "Exit with Save" barcode.