Function Application
‑563‑
Value
Function
Value Range
10
Length 0% to 100.0% (maximum length set by FB‑
05)
11
Count value
0% to 100.0% (maximum count value set
by FB‑08)
12 Communication
0.0% to 100.0% (AO communication)
13
Motor speed 0.0% to 100.0% (maximum output
frequency F0‑10)
14 Output current
0.0 A to 1000.0 A. 100.0% corresponds to
1000.0 A.
15
Output voltage 0.0 V to 1000.0 V. 100% corresponds to
1000.0 V.
16
Output torque of the motor
(actual value, a percentage
of the rated motor torque)
0% (twice the rated motor torque in
reverse direction) to 100% (twice the rated
motor torque in forward direction). 50%
corresponds to 0.
19 Taper output
‑
20
Roll diameter output 100.0% corresponds to B0‑08 which
specifies the maximum roll diameter.
21
Tension output
100.0% corresponds to B1‑02 which
specifies the maximum tension.
22
Encoder feedback frequency 100.0% corresponds to the value of F0‑10
which specifies the maximum frequency.
The following is an example of how to calculate the AO zero offset coefficient (F5‑10)
and AO gain (F5‑11):
Assume that the AO outputs the running frequency, and the rectified output needs to
be 8 V (Y1) when frequency is 0 Hz (X1) and 4 V (Y2) when frequency is 40 Hz (X2).
Gain formula:
Zero offset coefficient formula:
Xmax (Max. output frequency) is 50 Hz (assuming that the maximum frequency F0‑10
is 50 Hz), and Ymax (voltage) is 10 V.
In this case, AO gain (F5‑11) is –0.5 and AO zero offset coefficient (F5‑10) is 80%.
To Next Page
Loading...
