Inovance MD500-PLUS Series - AF Process Data Address Mapping Parameters

Parameter Groups
‑392‑
Description
When analog current correction is carried out on the AO1, a correction curve is
formed through two points. Each point corresponds to a target voltage and a
measured current. The target current is the expected output current, and the
measured voltage is the output current actually measured.
AC-30
AO1 measured current 2
Address:
0xAC1E
Min.:
0
Unit:
mA
Max.: 20 Data type: UInt16
Default:
16
Change: In real time
Value Range:
0.000 mA to 20.000 mA
Description
When analog current correction is carried out on the AO1, a correction curve is
formed through two points. Each point corresponds to a target voltage and a
measured current. The target current is the expected output current, and the
measured voltage is the output current actually measured.
AC-31 AO1 target current 2
Address:
0xAC1F
Min.:
0
Unit:
mA
Max.: 20 Data type: UInt16
Default:
16
Change: In real time
Value Range:
0.000 mA to 20.000 mA
Description
When analog current correction is carried out on the AO1, a correction curve is
formed through two points. Each point corresponds to a target voltage and a
measured current. The target current is the expected output current, and the
measured voltage is the output current actually measured.
2.23 AF Process Data Address Mapping Parameters
AF-00
RPDO1-SubIndex0-H
Address:
0xAF00
Min.:
0
Unit:
‑
Max.: 0xFFFF Data type: UInt16
Default:
0
Change: In real time
Value Range: