Inovance MD500-PLUS Series - FP User Parameters

Parameter Groups
‑320‑
Description
Same as FE‑00
2.16 FP User Parameters
FP-00
User password
Address:
0x1F00
Min.:
0
Unit:
‑
Max.: 65535 Data type: UInt16
Default:
0
Change: In real time
Value Range:
0 to 65535
Description
Used to set the user password.
FP-01
Parameter initialization
Address:
0x1F01
Min.:
0
Unit:
‑
Max.: 503 Data type: UInt16
Default:
1
Change:
At stop
Value Range:
0: No operation
1: Restore to factory parameter mode 1
2: Clear records
4: Recover user backup parameters
501: Back up current user parameters
503: Restore to factory parameter mode 2
Description
This parameter is used to set the corresponding action upon parameter
initialization of the AC drive.
0: No operation
The AC drive does not perform any operation.
1: Restore to factory parameter mode 1
Most of the AC drive parameters are restored to factory settings. However, motor
parameters, F0‑22 (decimal places of frequency reference), fault records, F7‑09
(accumulative running time), F7‑13 (accumulative power‑on time), F7‑14
(accumulative power consumption), and F7‑07 (IGBT heatsink temperature) are
not restored.
2: Clear records
The fault records, F7‑09 (accumulative running time), F7‑13 (accumulative power‑
on time), and F7‑14 (accumulative power consumption) are cleared.