Inovance MD500-PLUS Series - Page 628

Function Application
‑627‑
Figure 3‑73 Surface winding/unwinding
Para.
No.
Name Default
Value Range Description
B0‑08
Maximum roll
diameter
500.0 mm
0.1 mm to 6000.0
mm
The actual full roll diameter.
In the tension control mode, this parameter provides the
following functions:
1. Setting the upper limit for roll diameter calculation;
2. Calibrating values related to roll diameter(see B0‑07
and B0‑10);
3. Resetting the optional unwinding roll diameter (see
B0‑10).
Para.
No.
Name Default
Value Range Description
B0‑09 Reel diameter 100.0 mm
0.1 mm to 6000.0
mm
The actual reel diameter.
In the tension control mode, this parameter provides the
following functions:
1. Setting the lower limit for roll diameter calculation;
2. Resetting the optional winding roll diameter (see B0‑
10).