Appendix F: POST Error Code Intel® Server Board S2600CW Family TPS
Revision 2.4
Appendix F: POST Error Code
Most error conditions encountered during POST are reported using POST Error Codes. These
codes represent specific failures, warnings, or informational messages that are identified with
particular hardware units. These POST Error Codes may be displayed in the Error Manager
display screen, and are always automatically logged to the System Event Log (SEL). Being
logged to SEL means that the error information is available to System Management
applications, including Remote and Out of Band (OOB) management. The table below lists the
supported POST Error Codes, with a descriptive Error Message text for each. There is also a
Response listed, which classifies the error as Minor, Major, or Fatal depending on how serious
the error is and what action the system should take. The Response column in the following
table indicates one of these actions:
Minor: The message is displayed on the screen or on the Error Manager screen, and an
error is logged to the SEL. The system continues booting in a degraded state. The user
may want to replace the erroneous unit. The POST Error Pause option setting in the
BIOS setup does not have any effect on this error.
Major: The message is displayed on the Error Manager screen, and an error is logged to
the SEL. The POST Error Pause option setting in the BIOS setup determines whether
the system pauses to the Error Manager for this type of error so the user can take
immediate corrective action or the system continues booting.
Fatal: The system halts during post at a blank screen with the text Unrecoverable fatal
error found. System will not boot until the error is resolved and Press <F2> to enter
setup. The POST Error Pause option setting in the BIOS setup does not have any effect
on this class of error.
Table 96. POST Error Codes and Messages
System RTC date/time not set
PCI component encountered a PERR error
PCI out of resources error
Processor core/thread count mismatch detected
Processor cache size mismatch detected
Processor family mismatch detected
Processor Intel(R) QPI link frequencies unable to synchronize
Processor model mismatch detected
Processor frequencies unable to synchronize
BIOS Settings reset to default settings
Passwords cleared by jumper
Password clear jumper is Set
To Next Page
Loading...
