Intellian FB250 - Page 6

FB250/Fleet One - Marine Satellite Communication System
6
List of Figures
Chapter 4. Planning Installation 14
Figure 1: Potential RF Interference 14
Figure 2: RF Hazard Precautions 15
Figure 3: Above Deck Unit (ADU) / Antenna Unit 16
Figure 4: Below Deck Unit (BDU) 16
Figure 5: Unpacking System Package (with ADU & BDU Sub-package) 20
Figure 6: Unpacking BDU Package 20
Figure 7: Unpacking ADU Package 21
Chapter 5. Installing ADU 22
Figure 8: Antenna Dimensions 22
Figure 9: ADU Mounting Hole Pattern 23
Figure 10: Recommended Mast Design 25
Figure 11: Mounting Antenna on Mast 26
Figure 12: Installing 40 A Pole Bushing inside Pole Tube 27
Figure 13: Installing Pole Bracket 27
Figure 14: Mounting Antenna on Pole Mounted Bracket 27
Figure 15: Connecting Antenna RF Cable 28
Chapter 6. Installing BDU 29
Figure 16: BDU Dimensions (Direct Mounting Type) 29
Figure 17: BDU Dimensions (19-inch Rack Mounting Type_Optional) 30
Figure 18: BDU Mounting Template 31
Figure 19: Direct Mounting of BDU 32
Figure 20: Attach Cable Tray to BDU 32
Figure 21: Attach Rackmount Plate to BDU 33
Figure 22: Mount BDU Assembly into 19” Rack 33
Figure 23: System with Connected Devices for FB250 and not Fleet One 34
Figure 24: BDU Back Panel View 35
Figure 25: DC Power Connector Pinout 35
Figure 26: Antenna Connector (TNC) Pinout 36
Figure 27: LAN Connector (RJ45) Pinout 36
Figure 28: POTS Phone Connector (RJ14 & 6P4C) Pinout 36
Figure 29: GPIO Connector Pinout 37
Figure 30: DC Power to BDU Connection 39
Figure 31: BDU to Antenna Cable Connection 42
Figure 32: BDU to Devices Cable Connection using LAN Port (RJ45) 42
Figure 33: BDU to Device Cable Connection using WAN Port 43
Figure 34: BDU to POTS Phone (RJ14) Cable Connection 43
Figure 35: Using Cable Splitter with POTS Phones (RJ14) 43
Figure 36: BDU to External Devices Connection 44
Figure 37: Wi-Fi Antenna to BDU Connection 44
Figure 38: Grounding Stud Connection 44