Precautions
9
* DO NOT SHIP VIA RAIL: Ensure not to ship any system via Rail.
* Shock Hazard: To minimize shock hazard and to protect against lightning, you must connect the
equipment chassis and cabinet to an electrical ground. Make sure the system is correctly grounded and
power is off when installing, configuring, and connecting components.
* Do not operate in an explosive atmosphere: Do not operate the equipment in explosive environments
or in the presence of flammable gases. Operating this equipment in such an environment causes a
definite safety hazard.
* Keep away from living circuits: Operating personnel must at all times observe all safety regulations.
Do not replace components or make adjustment inside the equipment with any power supply turned on.
Under certain conditions, dangerous potentials may exist in the power supplies even with the power cable
removed. To avoid injuries, always remove the power and discharge a circuit before touching it.
To Next Page
Loading...
Need help?
General
