ITech IT8000 Series Programming Guide

Error Messages
Error
Code
Error Message Description
-276 Macro recursion error Macro recursion error
-277 Macro redefinition not allowed Redefinition macros are not
allowed
System errors
-310 System error [generic] System error (general)
-350 Too many errors [errors be-
yond 9 lost due to queue
overflow]
Too many errors (more than 9
error messages were lost due
to queue overflow).
Query errors
-499 sets Standard Event Status
Register bit #2
When a query error occurs, the
second bit of the standard sta-
tus register is set to 1.
-400 Query error [generic] Generic error query
-410 Query INTERRUPTED [query
followed by DAB or GET before
response complete]
A condition causing an inter-
rupted query error occurred.
-430 Query DEADLOCKED [too
many queries in command
string]
A condition causing a dead-
locked query error occurred.
-440 Query UNTERMINATED [after
indefinite response]
A query was received in the
same program message after a
query indicating an indefinite
response was executed.
Self-test errors
1 Module Initialization Lost Module initialization lost
2 Mainframe Initialization Lost Host initialization lost
3 Module Calibration Lost Module calibration data is lost
4 Non-volatile RAM STATE sec-
tion checksum failed
Non-volatile RAM area verifica-
tion failed
5 Non-volatile RAM RST section
checksum failed
Non-volatile RAM area reset
failed
10 RAM selftest RAM self-test error
Copyright © Itech Electronic Co., Ltd.
183

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English