Preservation and Storage
Cleaning
Preservation and Storage
Cleaning
General
WARNING When using cleaning agents, solvents or other chemicals, you must adhere to the manufacturer's
instructions and safety precautions.
WARNING Airborne particles of light combustible material such as straw, grass, wood shavings, etc. must
not be allowed to accumulate within the battery compartment. Examine these areas frequently and clean
at the beginning of each work shift or more often if required. Before opening the battery cover, make sure
that the top is clear of debris.
CAUTION To avoid burning, wear personal protective equipment when handling hot components. To protect
your eyes, wear goggles when using a brush to clean components.
Notice: Cleaning metal parts with incorrect solvents can cause corrosion. Use only recommended cleaning
agents and solvents.
Notice: The efficiency of the rams will be affected if they are not kept free of solidified dirt. Clean dirt from
around the rams regularly. When leaving or parking the machine, close all rams if possible to reduce the
risk of weather corrosion.
Notice: Never use water or steam to clean inside the operator station. The use of water or steam could
damage the machine electrics and render the machine inoperable. Remove dirt using a brush or damp cloth.
Clean the machine with water and/or steam. Do not let mud, debris etc. to collect on the machine.
Before you do any service procedures that require components to be removed:
• The cleaning must be done either in the area of components to be removed, or in the case of major work.
The whole machine must be cleaned.
• When cleaning is complete, move the machine away from the wash area or alternatively, remove the
material washed from the machine.
When you remove components, be aware of exposure to dirt and debris. Cover any open ports and remove
the deposits before proceeding.
Refer to the individual clean procedures throughout the Maintenance section. Refer to: Maintenance Schedules
(Page 112).
Detergents
Do not use a full strength detergent. Always dilute the detergents as per the manufacturer's recommendations,
or damage to the paint finish can occur.
Always obey the local regulations regarding the disposal of debris created from cleaning the machine.
Pressure Washing and Steam Cleaning
CAUTION When using a steam cleaner, wear safety glasses or a face shield as well as protective clothing.
Steam can cause personal injury.
Notice: The batteries and other electrical components could be damaged by high pressure washing
systems. Special precautions must be taken if the machine is to be washed using a high pressure system.
Do not directly pressure wash the electrical components. Use a low pressure washer and brush to remove
dried mud or dirt.
Use a steam cleaner to remove soft dirt and oil.
When cleaning around decals:
• Ensure the water pressure is kept below 138bar (2,000.0psi).
101 9831/8250-4 101
JCB © Admin Pimteam - 23/06/2021 05:32.