Preservation and Storage
Cleaning
• Keep water temperature below 80°C (175.9°F).
• Use a spray nozzle with a 40° wide angle spray pattern.
• Keep the nozzle at least 300mm away from and perpendicular (at 90° degrees) to the decal.
The machine must always be greased (if appropriate) after pressure washing or steam cleaning.
Preparation
1. Make the machine safe.
Refer to: Maintenance Positions (Page 116).
2. Stop the machine and let it cool for at least one hour. Do not try to clean any part of the machine while
it is running.
3. Make sure that all of the electrical connectors are correctly coupled. If the connectors are open, attach the
correct caps or seal with water proof tape.
102 9831/8250-4 102
JCB © Admin Pimteam - 23/06/2021 05:32.
To Next Page
Loading...
