jcb 19C-1E User Manual

Maintenance
Lubrication
Lubrication
General
CAUTION Waxoyl contains turpentine substitute which is flammable. Keep flames away when applying
Waxoyl. Waxoyl can take a few weeks to dry completely. Keep flames away during the drying period.
Do not weld near the affected area during the drying period. Take the same precautions as for oil to keep
Waxoyl off your skin. Do not breathe the fumes. Apply in a well-ventilated area.
You must grease the machine regularly to keep it working efficiently. Regular greasing will also lengthen the
machine's working life.
Refer to the individual condition checks throughout the Maintenance section.
The machine must always be greased after pressure washing or steam cleaning.
Greasing must be done with a grease gun. Normally, two strokes of the grease gun is sufficient. Stop greasing
when fresh grease appears at the joint.
Use only the recommended type of grease. Do not mix different types of grease, keep them separate.
Attach the dust caps after greasing (if installed).
Preparation
Make the machine safe. Refer to: Maintenance Position (Excavator End Lowered) (Page 116).
You can complete the greasing procedures with the excavator lowered.
127 9831/8250-4 127
JCB © Admin Pimteam - 23/06/2021 05:32.

jcb 19C-1E Specifications

General

Battery Type	Manganese laminated Lithium-ion
Battery Rated Capacity	14.8 kWh (3 Pack) 19.8 kWh (4 Pack)
Charging	On-board charger with direct connection from AC mains power supply
Charging Time	110V – 12 hrs 230V – 8 hrs
Fast Charging (Optional)	Off-board charger, with connection to 415V 3-Phase supply Charging time <2 hrs
System Voltage	48V
Motor Type	AC permanent magnet
Motor Power	7 kW continuous 20kW peak
Operating Modes	L – 1200rpm G – 1600rpm H – 1800rpm Auto Kick Up – 2300rpm, 2 speed tracking only
Thermal Limitations	Operation: -10oC to +46oC Charging: -10oC to +40oC