Operation
Stopping and Parking
Stopping and Parking
General
WARNING Make sure that the excavator is in a safe condition.
CAUTION Low speed must always be selected when unloading the machine from a vehicle or tracking down
steep slopes. The machine will take longer to stop when the levers are released if high speed is selected.
1. Park the machine on solid, level ground.
2. Release the two track levers then turn the hand throttle control to the idle position.
3. Lower the bucket and dozer to the ground.
4. Stop the machine.
5. Discharge the hydraulic pressure.
Refer to: Discharge (Page 138).
6. Turn off the ignition and remove the ignition key.
7. Switch off all unnecessary switches. If you are leaving the machine, make sure that all switches are set
to off.
8. Leave and secure the machine.
8.1. Raise the left armrest to isolate the hydraulic controls.
8.2. Use the handrails to leave the cab.
8.3. If you are leaving the machine for a long period, make sure that the all the access apertures are
secured and locked (if a lock is installed).
Emergency Stop Procedure
Switch the motor off with the key and then lower the excavator arm safely to the ground. Refer to: Excavator
End (Emergency Operation) (Page 71).
41 9831/8250-4 41
JCB © Admin Pimteam - 23/06/2021 05:32.
To Next Page
Loading...
