Operation
Operating Levers/Pedals
Figure 41.
A Track extension lever B Upward- retract
C Downward- extend
Auxiliary Circuit Controls
WARNING Before operating the auxiliary control system make sure that you are aware of all safety notices
that apply to the attachment you are using. Also make sure you have installed the attachment correctly and
have read its operator's manual.
Notice: The auxiliary hydraulic circuit a single acting system as standard with optional double acting system
available. If applicable make sure that the single/double acting control is correctly configured for your
attachment before operating it otherwise machine damage could occur.
Electro-proportional Controls
Attachments are operated using the joysticks.
Use the auxiliary switch on the right hand console to select either single acting or double acting (AUX1/AUX2)
operation. Check the instrument panel.
The electro-proportional wheel control on the right joystick controls swing or AUX1 attachments (press the
change over button on the left joystick to select auxiliary mode). An icon is displayed on the instrument panel.
The finger button on the right joystick can be used for hammer (constant full flow).
The electro-proportional wheel control on the left joystick controls AUX2 attachments.
58 9831/8250-4 58
JCB © Admin Pimteam - 23/06/2021 05:32.
To Next Page
Loading...
