jcb 19C-1E User Manual

Maintenance
Hydraulic System
• Abnormal noises.
Do not use the machine if one or more of these faults are found. You must make sure that the hydraulic service
is repaired immediately.
Oil
Check (Level)
1. Make the machine safe with the boom lowered.
Refer to: Maintenance Position (Excavator End Lowered) (Page 116).
2. Get access to the hydraulic oil level indicator and hydraulic oil filler cap.
Refer to: Service Points (Page 117).
3. Check the hydraulic oil level indicator. The hydraulic oil level must be visible in the level indicator.
4. Top up oil level if necessary:
4.1. Remove the hydraulic oil filler cap.
4.2. Add hydraulic oil.
Refer to: Fluids, Lubricants and Capacities (Page 156).
4.3. Install the filler cap.
Cylinders / Rams
Check (Condition)
Extend each ram fully, one at a time and visually examine for score marks, dents, leaks or similar defects.
Make the machine safe before inspecting each ram.
If a ram piston appears defective, contact your service engineer or JCB dealer.
140 9831/8250-4 140
JCB © Admin Pimteam - 23/06/2021 05:32.

jcb 19C-1E Specifications

General

Battery Type	Manganese laminated Lithium-ion
Battery Rated Capacity	14.8 kWh (3 Pack) 19.8 kWh (4 Pack)
Charging	On-board charger with direct connection from AC mains power supply
Charging Time	110V – 12 hrs 230V – 8 hrs
Fast Charging (Optional)	Off-board charger, with connection to 415V 3-Phase supply Charging time <2 hrs
System Voltage	48V
Motor Type	AC permanent magnet
Motor Power	7 kW continuous 20kW peak
Operating Modes	L – 1200rpm G – 1600rpm H – 1800rpm Auto Kick Up – 2300rpm, 2 speed tracking only
Thermal Limitations	Operation: -10oC to +46oC Charging: -10oC to +40oC