About the Product
Product and Component Identification
WARNING When replacing or repairing the ROPS/FOGS/TOPS structure you must replace the fixings.
Never re-use fixings. Use only new genuine JCB fixings tightened to the torque figures specified in the
operator's manual.
ROPS and TOPS Data Plate
Machines built to the ROPS (Roll-Over Protective Structure) and TOPS (Tip-Over Protective Structure)
standards have an identification label attached to the cab/canopy. Refer to Figure 6.
FOGS Data Plate
If the machine is used in any application where there is a risk of falling objects then a FOGS (Falling Object
Guard System) must be installed. For further information, contact your JCB dealer.
The FOGS has a data plate attached. The data plate indicates what level of protection the structure provides.
There are two levels of FOGS:
• Level I Impact Protection- impact strength for protection from small falling objects (e.g. bricks, small
concrete blocks, hand tools) encountered in operations such as highway maintenance, landscaping and
other construction site services.
• Level II Impact Protection- impact strength for protection from heavy falling objects (e.g. trees, rocks) for
machines involved in site clearing, overhead demolition or forestry.
Machine fitted with canopy, FOGS guard is integrated into canopy roof plate.
Level I FOGS guard only available with these machine. Refer to Figure 6.
9 9831/8250-4 9
JCB © Admin Pimteam - 23/06/2021 05:32.
To Next Page
Loading...
