Appendix A Test Results
OAM results
284
HST-3000 Ethernet Testing User’s Guide
Table 27 describes the Service Layer OAM LTM results. LTM/
LTR (Trace) must be Enabled to observe these results.
Table 28 describes the Link Layer OAM Local Op Mode
results. The Link OAM State must be On to observe these
results.
Table 27 S-OAM LTM test results
Result Description
Total Tx LTM
Frames
Count of the total number of LTM
frames transmitted since the last OAM
setting was specified or changed.
Total Rx LTR
Frames
Count of the number of LTR frames
received since the last OAM setting
was specified or changed.
Total Rx LTM
Frames
Count of the number of LTM frames
received since the last OAM setting
was specified or changed.
Total Tx LTR
Frames
Count of the total number of LTR
frames transmitted since the last OAM
setting was specified or changed.
Table 28 L-OAM Local Op Mode test results
Result Description
Mode Displays the current mode (Active or
Passive) for the instrument.
Parser Action Indicates the local receiver is currently
forwarding, looping back, or discarding
non-OAM PDUs.
Muxer Action Indicates the local transmitter is cur-
rently forwarding or discarding
non-OAM PDUs.
Vendor OUI Displays the Vendor OUI (Organiza-
tionally Unique Identifier) for the instru-
ment.
To Next Page
Loading...
