4-28
Vector Display
・Function・ The interval of the current vector in which it displays it on the track is set.
Whether the current vector is displayed at the rate once every times of "Storage interval" in
the previous clause how many is specified.
Setting value: [1/1 2 4 10 20 50] times
Ex.: When the setting is 1/2, the current vector is displayed on the track at the rate once
every 12 seconds for six seconds the setting of "Storage interval".
Operation Standard Menu: Plot screen setting menu/Vector display: 1/2 times
Selection Frame Menu: Plot drawing menu/Vector display: 1/2 times
Local Time
・Function・ The time difference to convert from the world standard time to the local time is set.
Setting value: [ +9.0 ] h
The numerical value in the hatching part increases and decreases by the key
operation in 0.5 hour step. The time difference is selected, and it fixes with the [ENT] ke y.
Operation Standard Menu: Plot screen setting menu/Local time: +9.0 h
Selection Frame Menu: Plot drawing menu/Local time: +9.0 h
・Display at date・
The date and time from GPS are displayed at the center under the screen. Time is
converted to local time.
Ex.) Standard time: 00:30 January 1, 2010 / In case of Menu setting Local time: +9.0 h
Date 10-01-01 09:30 is displayed at the date.
Input the present date from the menu when turning on power without GPS. The date of
data is not understood when the saved data is play backed later if there is no input at the
date. It becomes blank when GPS is not connected and there is not an input of time by
manually either.
Ship Speed Vector Length
・Function・ The length of the ship speed vector is set to the ship mark on the [PLOT] screen.
Setting value: [ 0.5 1 2 4 ] cm/10kn
Ex.: When the setting is 4, the vector length is displayed to ship speed 10kn by 4cm.
Operation Standard Menu: Plot screen setting menu/Ship speed vector length: 4 cm/10kn
Selection Frame Menu: Plot drawing menu/Ship speed vector length: 4 cm/10kn
Track Line Display
・Function・ The track where the set time passes disappears on the screen. When you do not see the
[PLOT] screen easily by displaying the track line, do it non-display or set the display time
short.
Setting value: [ 60 ] minutes
It selects with the key from among the numerical value [Non-display 1 - 60 - 1440
minutes) in the hatching part, and it fixes with the [ENT] key.
Operation Standard Menu: Plot screen setting menu/Track line display: 60 minutes
Selection Frame Menu: Plot drawing menu/Track line display: 60 minutes
*1 Time setting menu Refer to 3.1.1 “Power ON and Date/Time Setting”.
Ship Speed Vector
Direction: Course
Length: Ship Speed
Ship Mark
▲
▼
▲
▼
To Next Page
Loading...