4-63
DGPS Description
AUTO Selects beacon or SBAS automatically.
When both a beacon and SBAS can be received, priority is given to a
beacon.
When neither a beacon nor SBAS can be received, GPS positioning is
performed.
BEACON Performs DGPS by using a beacon.
When a beacon cannot be received, GPS positionin
is performed.
SBAS Performs DGPS by SBAS.
When SBAS cannot be received, GPS positionin
is performed.
OFF DGPS positionin
is not performed.
・When a correction mode is set in multi-GNSS mode, the positioning system is automatically
switched to “GPS”. In this case, the system is set to non-positioning temporarily.
・When setting SBAS, it takes time to SBAS positioning because it searches SABS satellites.
Memo
To Next Page
Loading...
