4-33
4.6 Executing a Route
A registered route or a temporary route can be executed.
The following route selection methods are available.
(1) Select a route from a route list.
(2) Select a waypoint by using the GOTO key.
(3) Select a route by using the GOTO key.
(4) Select a temporary route by using the GOTO key.
A route cannot be executed at the position exceeding North latitude/South latitude 89 degrees.
For the route width, arrival radius, planned ship speed of the temporary route that was created
by GOTO, the initial values of the route are used. For the setting of route initial values, refer to
“4.5.7 Setting route initial values”.
The waypoint is updated when the ship arrives at the arrival circle.
4.6.1 Executing a route by selecting from a route list
A route can be executed by selecting from a route list.
Procedure
1.
2. Set each item.
Item Description
ROUTE Displa
s the route number to be executed.
LEG CHANGR Select a wa
point update method.
AUTO: When the ship arrives at the arrival circle (normal route) or WOL
(TSC route), the waypoint is updated automatically.
is displayed.
"WPT CHANGE" is displa
ed for 5 seconds.
MANUAL: When the ship arrives at the arrival circle (normal route) or
WOL (TSC route), the effect is notified to the user. The waypoint is to be
updated manually.
is displayed.
"PLEASE PUSH "OK" AND CHANGE A ROUTE is displayed. Tap “OK”.
The wa
point is updated.
DIRECTION Set an order of the waypoints to be executed.
ORDER: Executes the route in the order of waypoints.
REVERSE: Executes the route startin
from the last wa
point.
NAVIGATION Executes the route.
START: Executes the route.
END: Ends the route.
To Next Page
Loading...
Need help?
General
